SAFETY BLANKET, TURBOCHARGER, 30″, FOR S4 SIZE, SUPER FARM, SOME 2.6

$375.00

Description

SAFETY BLANKET FOR COMPRESSOR SIDE OF TURBO ON SUPER FARM, SOME 2.6, OTHER TURBOS WITH S4 SIZE HOUSINGS.  30″ LONG

  • This blanket is designed for S4 size compressor housings.
  • 30″ long
  • Meets PPL and NTPA standards

Pro Stock version is available for HX82 turbo housings.  It is approximately 40″ long.

The 4.1, 3.6, 3.0 and some 2.6 version is available for H5 turbo housings.  It is approximately 34″ long.

NOT SURE WHERE TO MEASURE?  START AT THE INSIDE OF THE SNAIL AND GO AROUND THE OUTSIDE OF THE COMPRESSOR HOUSING TO THE FLANGE OF THE OUTLET.

Turbo Blanket required by PPL & NTPA – Made by Taylor Motorsports
Rule Clarification:The rule pertaining to the containment device on a multi turbo diesel truck or tractor has been changed to read: C. Turbocharger Containment Note: This rule only applies to turbocharger(s) with larger than 3 inch diameter inlet. 1.  Diesel Engines: Any single turbocharger or the turbocharger mounted directly to exhaust manifold on a multi turbo setup must have a Kevlar lined containment device (bag or blanket) that completely encloses the intake compressor housing. Bag or blanket used must be commercially available from a PPL & NTPA approved manufacturer.Note: containment device cannot be homemade.

Additional information

Weight 5 lbs
Dimensions 12 × 12 × 4 in

Brand

TAYLOR MOTORSPORTS

SAFETY EQUIPMENT

You may also like…